Specially formulated to fill narrow cracks in concrete floors
Watco Fine Crack Filler is a simple to use, incredibly tough product for filling unsightly cracks in concrete floors prior to coating. Its liquid formulation ensures that no sanding down will be needed to make it level once cured.
| Properties | Non shrink, two part liquid epoxy, can be coated, fast curing, ideal for cracks up to 2-3mm wide, its liquid formulation ensures that no sanding down will be needed to make it level once cured |
| Suitable for | Concrete |
| Appearance | Grey |
| Interior or Exterior | Exterior, Interior |
| Primer required | No primer required |
| Composition | 2 part, 100% solids epoxy resin |
| Number of components | 1 x resin, 1 x curing agent |
| Coverage | 25m x 2mm wide x 5mm deep crack per 500ml unit |
| Application tools | Straight edge or plastic/rubber scraper |
| Application | Pour carefully along the line of the crack |
| Curing time (at 20°C) | 3 hours |
| Minimum application temperature | 15°C |
| Pot life | Up to 20 minutes |
| Storage | Between 15°C - 25°C for at least 8 hours prior to use |
| Shelf life | 12 months in unopened container |
| Depth (mm) | 25mm |
| Principle limitations | Watco Fine Crack Filler will not remedy structural or bonding problems and are intended for surface filling only. Cracks caused by structural movement may reappear if movement persists |
Clean and rake out cracks ensuring that they are dry and free from dust etc. It is not normally necessary to 'chase out' cracks.
Each Watco Fine Crack Filler pack contains a tin of curing agent and a separate tin of resin. Add the contents of the curing agent tin to the tin of resin and stir thoroughly with a flat bladed mixer, or a slow speed drill fitted with a paddle. Scrape down the sides and bottom of the tin during mixing to avoid unblended resin/curing agent creating ‘soft spots’ in the cured product.
Pour carefully out of the tin onto and along the line of the crack and level off by using a straight edge or plastic/rubber scraper. Wipe away any excess. Leave to harden for 4 hours at 20°C before coating or overlaying. The repair may be coated with any type of floor paint or high performance coating e.g. Watco Epoxy Gloss Coat.
Please note: cracks in floors where one side has subsided can also be filled, but it will be impossible under these circumstances to achieve a flush finish. Watco Concrex may be used to make up differences in floor levels.
€41.30 (Ex VAT)
In stock
