Seals and resurfaces damaged and worn asphalt. Roll-on. No primer needed
Watco Asphalt & Concrete Resurfacer seals and resurfaces damaged and worn asphalt. It forms a flexible, sealed, waterproof surface that transforms old asphalt and tarmac.
| Suitable for | Old asphalt/tarmac, concrete, brick, masonry |
| Finish | Matt, smooth |
| Interior or Exterior | Exterior |
| Composition | Single pack, water based acrylic |
| Coverage | 15m2 at 2mm thick per 25kg |
| Number of coats | 1 |
| Recommended number of coats | 1 |
| Application tools | Medium pile roller |
| Dry film thickness | 800 microns |
| Curing time (at 15°C) | 15 hours |
| Minimum application temperature | 15°C |
Watco Asphalt & Concrete Resurfacer is flexible to allow for some movement in asphalt surfaces. Ensure surfaces are clean and free of loose material by brushing with a stiff broom and clean water. Allow to become dry, or almost dry, before applying the Asphalt & Concrete Resurfacer. If the surface has been previously painted, remove as much paint as possible by mechanical means. Any remaining paint should be well bonded and lightly abraded to provide a key.
Watco Bio-D, a bio-degradable water based degreasant can be used for grease removal from concrete and asphalt. Watco Asphalt & Concrete Resurfacer can be applied to a damp, but not wet, substrate. Damp down porous surfaces (but do not leave standing water) before application.
Stir the contents well with a wide bladed mixing tool to ensure that the product has not settled in transit.
Apply only in dry conditions (above 10°C and below 35°C). Do not apply in cold, damp conditions or when rain is forecast. In warmer conditions 25°C-35°C dry, hot surfaces should be slightly dampened first. Pour onto the surface and spread in one direction using a squeegee or roller to achieve a smooth finish. Alternatively it can be overrollered with a textured roller to create an anti slip finish. Do not apply the product in layers thicker than 2 mm. Never add water to the product.
