Your browser version is not officially supported, and you may experience a degraded service. Please upgrade your browser.

Watco Fine Crack Filler

Specially formulated to fill narrow cracks in concrete floors

  • 100% solids epoxy resin formula
  • Fast-drying, permanent repairs
  • Pourable two-part epoxy
  • Can be painted if required
Frequently bought together


Watco Fine Crack Filler is a simple to use, incredibly tough product for filling unsightly cracks in concrete floors prior to coating. Its liquid formulation ensures that no sanding down will be needed to make it level once cured.

Recommended areas of use

  • Specially formulated to fill narrow cracks in concrete floors
  • Small holes less than 50mm diameter and 25mm deep


  • Can be coated with any of our high performance floor coatings
  • Fast curing – non shrink
  • Super tough, epoxy resin formula
  • Ideal for cracks up to 3mm wide


Properties Non shrink, two part liquid epoxy, can be coated, fast curing, ideal for cracks up to 2-3mm wide, its liquid formulation ensures that no sanding down will be needed to make it level once cured
Suitable for Concrete
Appearance Grey
Interior or Exterior Exterior, Interior
Primer required No primer required
Composition 2 part, 100% solids epoxy resin
Number of components 1 x resin, 1 x curing agent
Coverage 25m x 2mm wide x 5mm deep crack per 500ml unit
Application tools Straight edge or plastic/rubber scraper
Application Pour carefully along the line of the crack
Curing time (at 20°C) 3 hours
Minimum application temperature 15°C
Pot life Up to 20 minutes
Storage Between 15°C - 25°C for at least 8 hours prior to use
Shelf life 12 months in unopened container
Depth (mm) 25mm
Principle limitations Watco Fine Crack Filler will not remedy structural or bonding problems and are intended for surface filling only. Cracks caused by structural movement may reappear if movement persists


Surface preparation

Clean and rake out cracks ensuring that they are dry and free from dust etc. It is not normally necessary to 'chase out' cracks. 


Each Watco Fine Crack Filler pack contains a tin of curing agent and a separate tin of resin. Add the contents of the curing agent tin to the tin of resin and stir thoroughly with a flat bladed mixer, or a slow speed drill fitted with a paddle. Scrape down the sides and bottom of the tin during mixing to avoid unblended resin/curing agent creating ‘soft spots’ in the cured product.


Pour carefully out of the tin onto and along the line of the crack and level off by using a straight edge or plastic/rubber scraper. Wipe away any excess. Leave to harden for 4 hours at 20°C before coating or overlaying. The repair may be coated with any type of floor paint or high performance coating e.g. Watco Epoxy Gloss Coat

Please note: cracks in floors where one side has subsided can also be filled, but it will be impossible under these circumstances to achieve a flush finish. Watco Concrex may be used to make up differences in floor levels.

Ask a question


Be the first to ask a question...

Ask a question
0 questions / 0 answers

€41.30 (Ex VAT)

In stock

Tools and accessories

What our customers say

Watco Fine Crack Filler