Your browser version is not officially supported, and you may experience a degraded service. Please upgrade your browser.

Watco Flowpatch Sub Zero

Fast & strong concrete repairs for heavy wear, cold areas. Cures down to -20°C

  • Easy to use rapid dry formula
  • Takes forklifts in just 2 hours
  • Magnesium phosphate-based formula
  • Just add water, mix and pour
Frequently bought together

Total price

€299.50 (Ex VAT)

This item: Flowpatch Sub Zero 25KG €246.05 (Ex VAT)

Description

Description

Watco Flowpatch Sub Zero is ideal for concrete floor repair in cold rooms. It will cure very rapidly to withstand heavy traffic, even at -20°C. Ideal for repairing holes or leveling damaged concrete floors. 

Features

  • Easy to use: just add water, mix and apply
  • Magnesium phosphate-based formula generates heat when mixed with water, allowing the product to be used as low as -20°C
  • Extremely tough: can withstand weight of up to 350kg/cm
Specifications

Specifications

Properties Will cure at minus 20 degrees, easy to use, just add water, mix and apply, magnesium phosphate-based formula, extremely tough.
Suitable for Concrete
Surfaces Floors.
Interior or Exterior Interior and exterior
Composition Magnesium phosphate cement based powder
Coverage 0.25m² per 10kg at 20mm, 0.6m² per 25kg at 20mm
Curing time 5 hours at minus 20°C
Minimum application temperature Minus 20°C
Application

Application

Surface preparation

Remove all loose material including dust, oil and grease. Minimum application depth should be 20mm. Repair edges should be cut to depth to avoid feather-edging. Dampen bare concrete with clean, cold water. Remove any standing water. Briefly warm the area using a blowlamp or gas torch. This helps to accelerate curing. 

Warning: do not mix the product for more than 4 minutes. Use immediately. Watco Flowpatch Sub Zero cures very quickly and the mixed product must be applied and finished within 10 minutes.

Mixing

Mixing must be carried out in an ambient temperature above 5°C. If mixing at temperatures below 5°C, pre-warm the mixing vessel with warm (approximately 25 - 30°C) water. Remove the bag of powder and pour 2 litres of clean, cold water into the plastic container. Gradually add all the powder, mixing thoroughly. Continue mixing to produce a smooth workable mortar.

Application

Trowel Watco Flowpatch Sub Zero firmly into place using a steel trowel or float. The trowel can be wiped with clean, cold water to make finishing easier. Apply the product at a minimum 20mm thickness, if using at a temperature range of - 20°C to 5°C.

Case studies

Case studies

Data sheets

Data sheets

Safety data sheets

Safety Data Sheet

Technical data sheets

Technical Data Sheet
Video

Video

Ask a question

Q&A

Be the first to ask a question...

Ask a question
0 questions / 0 answers

€246.05 (Ex VAT)

Low stock

Do you know the volume of the area?

Tools and accessories

What our customers say

Recently Viewed

Watco Flowpatch Sub Zero

Subscribe