Flexible waterproof protection for plant room floors
It is important that spillages or leaks in plant rooms are contained. Water or chemicals from a burst pipe or leaking tank could cause damage if it seeps through joints or cracks to rooms beneath. Watco Plant Room Coating is a high build, matt, lightly textured coating which provides seamless, flexible protection, filling and bridging joints and cracks.
Suitable for | Concrete, brick, masonry |
Finish | Matt, textured |
Interior or Exterior | Interior |
Composition | Cement and resin blend |
Number of components | 1 x milky white liquid, 1 x grey powder |
Coverage | Approximately 12.5m² per coat per 25kg |
Number of coats | 1 |
Recommended number of coats | 1 |
Dry film thickness | 1mm |
Curing time (at 20°C) | 16 hours |
Minimum application temperature | 5°C |
Pot life | 2 hours at 10°C. 1.5 hours at 20°C. 30 mins at 30°C |
Surfaces must be cleaned of all grease, dust, cement laitance and other contaminants. Dampen surfaces with clean, cold water. A minimum air and surface temperature of 5°C is essential.
Place the powder into the bucket along with the small bag of pigment (if using the red and green coloured version) and pour in approximately three quarters of the Watco Plant Room Coating liquid, mix using a slow speed drill and paddle mixer. Mix for approximately 3 minutes until a lump free, creamy consistency is achieved. Add the remaining liquid and mix thoroughly.
Application can be made by roller, trowel, or squeegee depending upon the finish required. The coating should be applied at approximately 1mm thick. If a second coat is required it can be applied as soon as the first is cured, normally 12-24 hours.
Curing at 15-20°C a floor treated with Watco Plant Room Coating can take light traffic after approximately 16 hours and heavy traffic after 3 days. Full chemical curing is achieved over 7 days. It is at this point the coating will resist permanent water pressure.