Repairs, waterproofs and reflects heat
Total price
€313.40 (Ex VAT)
Watco Roofite® Solar Reflective waterproofs and seals and is suitable for many exterior surfaces. Easy to brush on, Roofite® Solar Reflective avoids costly re-roofing and can be used as an emergency leak repair, even in the pouring rain!
| Properties | Thick bitumen, rubber and tough fibre reinforcement that weatherproofs and refurbishes roofs, bridges small holes/cracks and splits even in the pouring rain, easy brush-on application, heavy duty |
| Suitable for | Porous asbestos and fibre sheets, corrugated iron, concrete, tiles, felt |
| Finish | Silver grey, matt |
| Interior or Exterior | Exterior |
| Primer required | No |
| Composition | Single pack blend of rubber, polymer modified bitumen and aluminium flake |
| Coverage | 5m² per 5kg |
| Number of coats | 1 |
| Recommended number of coats | 1 |
| Application tools | Brush, trowel |
| Curing time (at 10°C) | 24 hours |
| Minimum application temperature | 5°C |
| Shelf life | 24 months in unopened container |
| Principle limitations | Roofite and Roofite Solar Reflective are not suitable for coating bare wooden substrates in order to form a waterproofing seal. Entrapped moisture on porous surfaces may cause blistering in warm weather or spalling at low temperatures. Only limited emergency patch repairs should therefore be made to porous surfaces while wet. Not suitable for use on EPDM rubber roofs. Check compatibility with other surfaces if in doubt. As it is common with all bitumen based products, black Roofite will gradually weather to grey colour For flat roofs which will be regularly walked on, please refer to Anti Slip Liquid Roof Membrane |
| Cleaning tools | Use white spirit before the product dries |
Surfaces should preferably be as dry as possible. Emergency patch repairs can however be successfully completed to surfaces with running water. Remove any loose material and dirt. Very porous, dry surfaces should be primed with Watco Roofite diluted with 25% white spirit. A wire brush should be used to remove all traces of moss etc. A fungicide may be required for heavily contaminated surfaces. Specialist advice must be sought when dealing with old asbestos/cement roofs.
The coating should be applied generously by brush at the rate of 1m² per kilo. If a second coat is required it should be applied at right angles to the first coat. Do not brush out to a thin film. Cracks, splits, holes and leaks around roof sheet overlaps should be treated in the following manner.
Apply a generous coat of Watco Roofite and immediately bed in a strip of Watco Scrim cut to a suitable size. Apply a further coat of Watco Roofite over the scrim using a stippling action and leave to cure. Deep pits and cracks in flat concrete roofs etc can be filled with a mortar consisting of Watco Roofite mixed with Roofite Additive. The surface should be primed first with Watco Roofite before trowelling in the Watco Roofite and additive mix.
In exceptional temperature conditions advice should be obtained from Watco’s Technical Department.
For flat roofs which will be regularly walked on, please refer to Watco Liquid Roof Membrane Anti Slip.
Increases viscocity of Roofite products for thicker application to larger cracks
€15.80 (Ex VAT)
