Hardens and dustproofs weak, dusty concrete
A colourless liquid resin which penetrates deep into concrete or other porous materials to provide a dust proofed, hardened surface. Watco Universal Sealer Dustproofer strengthens weak, dusty screeds and poor quality concrete. It also reduces porosity and dusting on brick, blockwork and plaster walls.
Watco Universal Sealer Dustproofer is easily applied to new or old concrete surfaces using a soft broom.
| Properties | Hardens and dustproofs porous concrete and similar surfaces, solvent-free and virtually odourless, very easy to apply, microporous -allows substrate to breathe, colourless. |
| Suitable for | Porous, bare concrete, sand and cement screeds, brick, blockwork, plaster, block paving |
| Finish | Clear |
| Surfaces | Floors, walls. |
| Interior or Exterior | Interior and exterior |
| Primer required | No primer required. |
| Composition | Single pack, water based acrylic |
| Coverage | 30m² per 5L |
| Number of coats | 1 |
| Recommended number of coats | 1 |
| Drying time | 12 hours at 15°C. |
| Curing time | 12 hours at 20°C |
| Minimum application temperature | 10°C |
A minimum of preparation is required; a good sweep to remove surface dust and dirt is often sufficient. The surface must be dry and porous to allow the Universal Sealer Dustproofer to penetrate. Oil and grease can be removed using Watco Bio D (or similar degreasant), the floor must then be rinsed with water and allowed to dry. If there is doubt that the subtrate is absorbent, pour some water onto the surface. If the water is easily absorbed, the surface is suitable for treating with Watco Universal Sealer Dustproofer. New concrete should not be treated until the surface is sufficiently dry to absorb the solutions (usually at least 7 days in good drying conditions). For more information click here.
Apply between 10°C – 30°C only. Pour directly onto the floor from the container. Use a soft broom to distribute the solution, working it well into the surface. Ensure that the surface has absorbed as much solution as it can. Avoid ponding, i.e. do not allow any surplus unabsorbed solution to remain and subsequently dry on the surface. Use the broom to sweep any excess solution onto adjacent areas. One coat is normally sufficient on average quality concrete. A second coat may be required on exceptionally porous substrates. Allow the surface 12 – 16 hours to dry before making a second application.
|
|
|
|
|
|---|---|---|---|---|
|
This product:
Watco Universal Sealer Dustproofer |
Watco Concrete Sealer Water Based |
Watco Powerfloat Sealer |
Watco Protecta-Coat |
|
|
From €81.15 (Ex VAT) |
From €88.55 (Ex VAT) |
From €128.30 (Ex VAT) |
€147.25 (Ex VAT) |
|
|
Please make a product selection to continue |
View | View | View | |
| Composition | Single pack, water based acrylic | Single pack, water based acrylic | 2 part, water based epoxy resin | 2 part polyaspartic resin |
| Durability | Heavy | Medium | Medium-heavy | Heavy |
| Hardens & dustproofs | ||||
| Seals the surface | ||||
| Interior or Exterior | Interior and exterior | Interior and exterior | Interior | Interior and exterior |
| Suitable for power floated concrete | ||||
| Number of coats | 1 | 2 | 1 | 1 |
|
Please make a product selection to continue |
View | View | View |
