Allows smooth concrete to be painted without mechanical preparation
Enables coatings to be applied to hard, smooth surfaces which would usually reject paint. Avoid using any coating which includes a strong solvent. For more information, please download a product datasheet from the quick links below.
Please note: Whilst Powerfloat Primer avoids the use of mechanical preparation, diamond grinding or shot blasting does provide a better finish overall and is recommended. For smaller areas where mechanical abrasion is difficult Powerfloat Primer is a great back-up option.
The following is based on good ventilation and a floor temperature of 15 -20°C
| Properties | An adhesive primer for smooth, non-porous surfaces |
| Suitable for | Power floated or smooth concrete |
| Appearance | Available in Clear or Light Grey finish |
| Finish | Powerfloat Primer is available in a smooth, matt grey finish or clear. Clear appears milky until it dries. |
| Interior or Exterior | Interior |
| Composition | 2 part, water based epoxy resin |
| Number of components | 1 x curing agent, 1 x resin |
| Coverage | 30m² per 5L |
| Recommended number of coats | 1 |
| Mix ratio | Powerfloat Primer Grey - 100 parts Curing Agent : 19.5 parts resin. |
| Wet film thickness | 160 microns |
| Dry film thickness | 120 microns |
| Curing time (at 20°C) | 6 hours |
| Minimum application temperature | 15°C |
| Pot life | Up to 2 hours at 20°C. |
| Storage | Between 15°C - 25°C for at least 8 hours prior to use. Do not allow to freeze |
| Shelf life | 24 months in unopened container |
New concrete should be allowed at least 28 days to dry. Surfaces should be clean, dry and free from oil, grease, dust, dirt and other contaminants. Existing coatings should be well bonded and sound.
The tall outer tin contains a tin of Resin and a tin of Activator. Remove these two tins and stir the contents of each thoroughly. Decant both tins into the tall outer tin. The two components should then be very thoroughly mixed together using a wide bladed stirrer. A wooden batten at least 25mm wide is ideal. Mix for 2–3 minutes until an even colour and consistency are obtained.
If appearance is critical we recommend the application of a small trial area first.
Decant the mixed components into a roller tray and apply using a medium pile type roller. A brush may be used for cutting in. Aim to apply the mixed components within one hour (they are usable for up to 2 hours maximum at 20°C). Do not apply at temperatures below 10°C or above 30°C. Cold or damp conditions may retard or prevent full curing. Avoid applying too thickly.
|
|
|
|
|
|---|---|---|---|---|
|
This product:
Watco Powerfloat Primer |
Watco 4 Hour Epoxy Primer |
Watco Epoxicote High Build Primer |
Watco Polyaspartic Primer |
|
|
From €128.30 (Ex VAT) |
€138.00 (Ex VAT) |
€100.35 (Ex VAT) |
€127.35 (Ex VAT) |
|
|
Please make a product selection to continue |
View | View | View | |
| Composition | 2 part, water based epoxy resin | 2 part, 100% solids epoxy resin | 2 part, water based epoxy resin | 2 part polyaspartic resin |
| Primes porous dusty surfaces | ||||
| Primes smooth & power floated concrete | - | |||
| Colour | Grey or clear | Clear | Grey | Clear |
| Can be used at low temperatures | ||||
| Can be applied to damp surfaces | ||||
|
Please make a product selection to continue |
View | View | View |
