For creating coved skirting often used in hygienic environments. Cures in 1 hour
A coved skirting helps cleaning by eliminating the dirt trap at the junction of the floor and the wall. Watco Concrex® Coving Mortar is specially formulated to make it easier to create coved skirting. Based on the technology of Watco Concrex®, this mortar is incredibly tough, chemical and impact resistant, even when applied with feather edges. Designed to be used in conjunction with Watco Tack Coat.
| Pendulum Slip Test Values | |
| Dry PTV | Wet PTV |
| 70 Extremely low slip potential | 62 Low slip potential |
| Properties | Can be feather-edged, impervious, non-dusting, impact and chemical resistant, fast curing, can be painted |
| Suitable for | Concrete, metal, brick, masonry |
| Finish | Smooth |
| Interior or Exterior | Exterior, Interior |
| Primer required | Yes |
| Composition | 2 part epoxy resin |
| Number of components | 2 |
| Coverage | 5m of 50mm x 50mm of cove skirting per 5kg |
| Application tools | Coving trowel |
| Application | Trowel firmly into the repair |
| Curing time (at 20°C) | 1 hours |
| Minimum application temperature | 10°C |
| Maximum operational temperature | 60°C |
| Pot life | Up to 30 minutes |
| Principle limitations | Do not steam clean or subject to temperatures in excess of 60°C |
Ensure surfaces are clean, dry and free from loose material. Wire brushing and sweeping should suffice, Watco Bio D can be used to remove grease and oil. Prepare at least 100mm at the base of the wall and 100mm at the floor edge to accommodate the skirting.
Watco Tack Coat should be applied at least 80mm up the base of the wall from the edge of the floor, where the cove skirting is to be applied. The coving mortar should be applied to the Tack Coat whilst it is still tacky.
A 5kg pack contains aggregate pre-blended with resin and a tin of curing agent. It is recommended that the whole pack is mixed at once (please note that once mixed, the product is usable for up to one hour). Do not mix the product inside the bucket. Put on protective gloves. Tip the aggregate into a mixing tray or a board. Shake the tin of curing agent thoroughly. Form the aggregate into a mound, leaving a small hole in the middle.
Empty the tin of curing agent into the hole, ensuring the contents are completely drained. Carefully mix the aggregate with the curing agent using a trowel until a smooth, grey mortar is obtained. The more thorough the mixing, the ‘wetter’, smoother and more manageable the mix becomes. Alternatively, you may find it easier to knead the mixture by hand, still wearing gloves. It is important to mix thoroughly, until you achieve a consistent grey colour.
Trowel the mortar firmly over the Tack Coat. Use the Watco Coving Trowel to achieve the cove radius. Moisten a rag with white spirit and frequently wipe the blade. This helps to achieve a good finish. The product can be feather edged, at the top and base of the coved skirting. If laying over an expansion joint, saw cut through the cured mortar, following the joint, to prevent random cracking.
€108.65 (Ex VAT)
In stock
